Step-by-step filling instructions
|
|
Step 1:
• Use on any tree/shrub with branches beginning at least 6" off the ground or higher
• Place bag on flat ground, or on top of a properly built mulch cup
> Clear all sharp objects from area to be watered
> For best results, use on level surface with mulch
• Wrap both side around the trunk with center hole around trunk base
> For use on trees up to 4" in diameter/caliper
|
|
Step 2:
• Pop open the red fill valve cap and insert water hose
> Recommended for use with standard sized garden hose
• Turn on water supply and begin filling with water.
> Use clean water - If necessary, filter water through cotton cloth on hose end
• After bag is at least 1/2 full, add premixed water soluble fertilizer, if desired.
> To prevent clogging, premix fertilizer in separate container
• To fill bag completely, gently lift on fill valve while filling.
> To prevent water spillage, keep fill valve elevated when closing cap
|
|
Step 3:
• Fill to desired level and let drip until empty
> Maximum capacity approximately 14 gallons of water
> Drip time of approximately 4 to 8 hours
• For newly planted trees, start with an initial fill schedule of 1 to 2 times per week
|
How much water does a newly planted tree require per week?
|
|
Recommended for use on flat surface or properly built mulch cup
|
The
placement of the two removable PVC emitters on the underside of each 14
gal. Treegator® Junior will ensure an even, steady drip rate provided
that the bag is resting on a flat surface, or properly built mulch cup.
Please
make sure that the mulch is either "cup-shaped" or flat. If the mulch
around the trunk is "mound-shaped", the bag may not empty completely,
and some water run-off may occur.
|
|
|
|
|